SPX Cooling Technologies CS4000 - Manual (Page 71)

CS4000 Mini Controller with Ethernet
Page 5-12 T-38324-A 39-30-38324
4. To change the IP address, subnet mask and/or default gateway:
a. Click on the IP Address:, Subnet Mask: or Default Gateway: field.
b. Enter the new value.
c. Repeat Steps a) and b) for all the fields you want to change.
5. Select the Comm Options tab.
a. From the Application Settings window, click on the Comm Options tab. See
Figure 5-15.
Figure 5-15. Selecting the Application Settings Window -
Comm Options tab
NOTE: When an option is enabled, there is a check mark in the box
next to it. When an option is disabled, the box is empty. Click on
the box to toggle the option between enabled and disabled.
6. To change the communication options:
a. Click on Enable API Communications over Ethernet to enable or disable the
Application Program Interface (API). When you disable this option, programs cannot
request data from the API over the Ethernet.
b. Click on Enable VS Communications over Ethernet to enable or disable Visual
Supervisor communications over the Ethernet. When you disable this option, all
Ethernet communications to and from Visual Supervisor are terminated.
c. Click on Enable 3964R Communications to enable or disable the Siemens 3964R
communications protocol used to transfer data to and from the barcode scanner
attached to the RS-422 port.