Salton, Inc JK-1199 - Manual (Page 3)

3
GROUNDED PLUG
To reduce the risk of electric shock this appliance has a grounded plug (2 blades
and 1 pin). If the plug does not fit fully into the electrical outlet contact a qualified
electrician. Do not modify the plug in any way or use an adaptor.
BEFORE FIRST USE
1. Read all instructions carefully and keep them for future reference.
2. Remove all packaging.
3. Water boiled for the first time should be discarded.
INSTRUCTION FOR USE
1. The Filter has been installed in the Kettle before shipping. If it has been
removed, install the Filter before using the Kettle. See the Care and
Cleaning section.
- DO NOT use the Kettle without the Filter in position as water may spill
out when boiling.
- DO NOT REMOVE THE FILTER WHEN THE KETTLE IS HOT.
2. Fill Kettle between the minimum and maximum levels shown on the Water
Level Window.
NOTE:
DO NOT attempt to fill while the Kettle is on the Power Base.
DO NOT use for other than boiling water. Other liquids will contaminate
the interior of the Kettle.
DO NOT fill past the MAX level indicated on the Water Level Window.
Overfilling may cause water to spill out when boiling.
3. Place Kettle on Base making sure it is correctly engaged on its Base.
4. Plug Power Base cord into a 120V AC wall outlet. NOTE: Never plug Power
Base with empty Kettle into the electrical outlet.
5. Depress the On/Off Switch to the ‘On’ position. The Indicator Light will
illuminate to indicate that the Kettle is in the boil cycle. Once the water
has boiled, the On/Off Switch will automatically switch to the ‘Off’ position
and the Indicator Light will go out.
Booklet_JK-1199_Eng.qxd:Silhouette 3/8/10 12:28 PM Page 3