Care and cleaning – Salton, Inc JK-1199 User Manual

Page 4

Advertising
background image

6. If you want to use the Kettle again, allow the thermal safety switch to cool

down for 15 – 20 seconds then depress the On/Off Switch to the On
position. If the On/Off Switch does not remain in the ‘On’ position,
the Water is hot enough to use without reheating.

7. Unplug cord from wall outlet before lifting Kettle from Power Base.

Grip the Kettle by the Handle only, as the surface and lid will be hot.

8. Return the Kettle to the Power Base or place on a heat resistant surface

after use.

9. If the Kettle is accidently switched on when empty, the thermostat will

automatically cycle switching the Kettle off and allowing it to cool down
then switching it back on. If this situation occurs, unplug the Power Base
and let the Kettle cool before refilling.

10. It is recommended that the power cord be disconnected from the wall

outlet when not in use. DO NOT attempt to connect any other appliance
to the Power Base or tamper with the connector in any way.

CARE AND CLEANING

1. Unplug power cord from wall outlet. Empty out remaining water and

allow Kettle to cool before cleaning.

2. If necessary, remove and clean the Aquascreen Filter

®

by rinsing under running

water. The Filter can be removed by grasping firmly between your thumb
and forefinger and gently twisting off starting at either the right or left edge.

3. Under normal use, a deposit of scale may form on the inside of the Kettle

and cause some discolouration. Scale, which has accumulated inside
the Kettle, can be removed by boiling equal parts of white vinegar and
water (500 ml / 2 cups of each is recommended). Once the water has
boiled, allow mixture to stand several hours or overnight. Empty out
mixture and fill Kettle to the MAX level with fresh water. Bring water
to a boil and discard. For heavy scale build-up, repeat this process.
NOTE: This build-up can be delayed by pouring out old water and refilling
before each use.

4. DO NOT USE ABRASIVE CLEANERS

5. DO NOT ALLOW WATER TO ENTER THE POWER BASE

6. DO NOT IMMERSE KETTLE OR POWER BASE IN WATER OR OTHER LIQUID. 4

Booklet_JK-1199_Eng.qxd:Silhouette 3/8/10 12:28 PM Page 4

Advertising