Smart Technologies PC - Manual (Page 20)

14 Camfire PC Installation and User's Guide
To connect the camera boom to a computer
1. Open the door at the bottom of the camera boom base and connect the IEEE 1394
cable to the Input port.
Be careful to use the correct port. When you’re facing the camera boom, the Input
port is the one on the left.
Door
Camera Boom Base
Input Port
IEEE 1394 Cable
Wire Management Hook
2. Close the door on the camera boom base.
3. Run the IEEE 1394 cable through the wire management hook, across the top of the
whiteboard and towards the computer.
You may want to use a raceway to keep the IEEE 1394 cable out of the way. For
example, Panduit Corporation offers LD surface raceways. For more information, visit
the Panduit Corporation Web site at www.panduitncg.com.
4. Connect the other end of the supplied IEEE 1394 cable to an IEEE 1394 port on the
computer.
If your computer doesn’t have an IEEE 1394 port, you can order an IEEE 1394 card
from SMART or a third-party supplier. If you order from SMART, ask for SMART
order No. SCF-1394D for a desktop computer, or SMART order No. SCF-1394L for a
laptop computer.