Sunbeam Bedding HE3100 - Manual (Page 10)

1. Place the heater on a flat level surface and
ensure that the air intake and outlet are
clear of obstructions.
Note: When turned on for the first time,
your new heater will emit a slight odour
for up to 8 hours. This is due to the initial
heating of the materials used. It is safe,
not detrimental to the performance of
the heater and will not reoccur. Sunbeam
advises that the heater be placed in a well
ventilated area during this period.
2. Ensure that the mode dial and thermostat
dial are both in the OFF position.
3. Insert the plug into a 230/240V power
outlet and turn the power on. The power
ON light will illuminate.
4. Move the mode dial to your desired heat
setting, either low heat (1) or high heat
(2).
5. Turn the thermostat dial clockwise until
the red thermostat indicator light turns on,
indicating that the heater is warming to
the selected temperature. This light will go
out when the selected temperature level is
reached.
6. The thermostat is now set and will
automatically maintain the pre-set
temperature level by turning the heater on
and off.
7. To adjust the selected temperature level,
rotate the thermostat dial anti-clockwise to
lower or clockwise to raise the temperature.
8. To turn the heater off, move the mode dial
to the OFF position.
8
Using your Convection Plus Heater
HE3100 – 1200W heater with micathermic elements