Sunbeam Bedding HE3100 - Manual (Page 11)

9
1. Place the heater on a flat level surface and
ensure that the air intake and outlet are
clear of obstructions.
(Refer to
Note on Page 8).
2. Ensure that the ON/OFF switch is in the
OFF position.
3. Insert the plug into a 230/240V power
outlet and turn the power on. Move the
ON/OFF switch (located on the side of the
heater) to the ON position. The ON/OFF
switch will then illuminate.
The LCD screen will display the ambient
room temperature.
Note: When the heater is switched on it will
be automatically set to the standby mode.
4. Press the mode button to select your
desired operating mode. Each time you
press the mode button, it will scroll
through the various settings as follows:
STANDBY
the heater remains inactive
when in this mode
LO
the heater will continuously run
at approximately 800 watts
HI
the heater will continuously run
at approximately 2200 watts
AUTO
for operating the digital
thermostat
5. To turn the heater off, move the ON/OFF
switch to the OFF position.
Using the remote control
The remote control allows you to conveniently
operate the heater from anywhere in the room.
The buttons on the remote control are
identical to the buttons on the heater. When
using your remote control simply follow the
normal operation instructions outlined on
pages 9 and 10 in addition to the points
below.
1. Ensure that the remote control contains
2 x AAA batteries.
2. Point the remote towards the infrared
receiver on the heater (located below the
plus/minus arrows). Ensure that there are
no objects blocking the path between the
remote and the infrared receiver.
3. Follow steps 1 to 4 on the left column of
this page.
Note: The maximum transmission distance
between the heater and remote is
approximately 30 metres.
Setting the digital thermostat
The digital thermostat allows you to set your
desired temperature for the room. The heater
will then cycle on and off to maintain it.
1. Follow steps 1 to 3 on the left column of
this page.
2. Press the mode button until the AUTO
mode is displayed. Once in AUTO mode,
the LED screen will flash your previous
pre-set temperature for 5 seconds. After
5 seconds the LED screen will display the
ambient room temperature.
Using your Convection Plus Heater continued
HE3900 – 2200W heater with micathermic elements and remote control