Samsung SRS600HNP - Manual (Page 23)

operating the SAMSUNG
side-by-side refrigerator
sEtting uP tHE rEfrigErator
Now that you have your new refrigerator installed and in place, you are ready to set up and enjoy the full
features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational. If not, first check the power
supply and electricity source or try the troubleshooting section at the back of this user guide. If you have any
further questions, contact your Samsung Electronics service center.
1. Place the refrigerator in an appropriate location with reasonable clearance between the wall
and the refrigerator. Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the
doors.
3. Set the temperature control to the coldest temperature and wait for an hour.
The freezer should get slightly chilled and the motor should run smoothly.
4. After powering the refrigerator, it will take a few hours to reach the appropriate temperature.
Once the refrigerator temperature is sufficiently cool, you can store food and drink in the
refrigerator.
using tHE anti-swEat HEatEr switCH
When the humidity of the indoor is high, sweat may form around the beverage station & dispenser. Turn the
Anti-sweat heater switch on, to remove the sweat and turn the switch off when the sweat disappears.
02
o
PE
ra
ting
operating _23
RS21/23H** (OPTIONAL)
DA99-02028A(HM09')-EN(0.0).indd 23 2009.6.10 5:8:22 PM