Sony VIDEO Plus SLV-SE30UX - Manual (Page 7)

Getting Started 7
Getting Started
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one together.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer’s code
number.
1
Set TV / VIDEO at the top of the remote commander to TV .
2
Hold down I /u, and enter your TV’s code number(s) using the
programme number buttons. Then release I /u.
Now you can use the following TV control buttons to control your TV:
I /u, TV/VIDEO, programme number buttons, ? (ten’s digit), PROG
+/–, Á +/–, ; (TV), V (Teletext), FASTEXT buttons, WIDE*, MENU*,
>*/.*/?*//*, and OK*.
* These buttons may not work with all TVs.
Tip
• When you set your TV’s code number correctly while the TV is turned on, the TV
turns off automatically.
continued
To
Switch to TV (Teletext off)
Switch to Teletext
Select the sound
Use FASTEXT
Call up on-screen display
Change the Teletext page
Switch to/from wide mode of a Sony wide TV (For
other manufacture’s wide TV, see “Controlling other
TVs with the remote commander” below.)
Press
; (TV)
V (Teletext)
AUDIO MONITOR
FASTEXT buttons
DISPLAY
√ /◊
WIDE