SUPER MICRO Computer AS1011M-T2 - Manual (Page 41)

Chapter 5: Advanced Motherboard Setup
5-7
5-5 I/O Ports
The I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-3 below for the colors and locations of the various I/O ports.
Figure 5-3. Rear Panel I/O Ports
5-6 Installing Memory
CAUTION
Exercise extreme care when installing or removing memory modules
to prevent any possible damage.
1. Insert each memory module vertically into its slot, paying attention to the notch
along the bottom of the module to prevent inserting the module incorrectly (see
Figure 2-2). Install to slot 1A fi rst, then 2A, etc. See support information below.
2. Gently press down on the memory module until it snaps into place.
Note: 256 MB, 512 MB, 1 GB and 2 GB memory modules are supported. It is highly
recommended that you remove the power cord from the system before installing or
changing any memory modules.