Sony KD-32DX150U - Manual (Page 7)

Getting started
5
Connecting an aerial and a VCR to the TV
Connecting an aerial and a VCR
Switching on the TV
3
4
1. Connect your existing aerial lead to the digital
socket marked
on the rear of the TV as
shown.
2. Connect the supplied RF loopthrough cable from
the socket marked
to the analogue socket
marked .
1. Connect your existing aerial lead to the digital
socket marked
on the rear of the TV as shown.
2. Connect the supplied RF loopthrough lead from the
lower socket marked
on the TV to the RF IN
socket on your VCR.
3. Connect a lead from the RF OUT socket of your
VCR to the analogue socket marked
on the TV.
4. Connect a scart lead from the socket marked
on the rear of the TV to the scart socket
on your VCR (refer to your VCR instruction
manual).
5. Connect the VCR to the mains socket and switch
on.
6. Insert a pre-recorded tape into the VCR and press
the ‘PLAY’ button. This enables the TV to locate
and store the video channel during the
‘Automatically tuning the TV’ procedure.
Note:
Your VCR sockets may not be labelled RF IN and RF OUT. If not,
please refer to your VCR instruction manual for guidance.
s 3 3
1. Connect the TV plug to your mains socket
(220 - 240 V AC, 50 Hz) and switch on.
2. Push in the on/off button (labelled ) on the
front of the TV.
Note:
If the red indicator on the front of the TV is lit the TV is in standby
mode. Press the TV
button on the remote control to switch on
the TV. Please be patient as the picture may take a few moments to
appear on screen.
/
Scart lead
(not supplied)
Rear of VCR
RF Loopthrough
lead (supplied)
Existing aerial lead
RF lead
(not supplied)
On/Off switch
RF Loopthrough
lead (supplied)
Existing aerial lead
Connecting an aerial only
1-8.fm Page 5 Monday, February 10, 2003 4:52 PM