Samsung BN68-01412T-00 - Manual (Page 28)

English - 
Checking the Digital-Signal Information
You can get information about the signal status.
1. Press the MENU button to display the menu.
Press the ▲ or ▼ button to select “Channel”, then press the ENTER
button.
2. Press the ▲ or ▼ button to select “Signal Information”, then press the
ENTER button.
3. Press the EXIT button to exit.
If the signal status is poor, the “No signal.” message is displayed.
While viewing a Digital channel, this function can be selected. ➣
➣
LNA (Low Noise Amplifier)
If the TV is operating in a weak-signal area, the LNA function can improve the reception (a low-noise preamplifier boosts the
incoming signal).
1. Press the MENU button to display the menu.
Press the ▲ or ▼ button to select “Channel”, then press the ENTER
button.
2. Press the ▲ or ▼ button to select “LNA”, then press the ENTER button.
3. Press the ▲ or ▼ button to select “Off” or “On”. Press the ENTER button.
4. Press the EXIT button to exit.
While viewing an Analogue channel, this function can be selected. ➣
Channel
Channel Mode : Added Ch.
Fine Tune
Signal Information ►
LNA : Off
Signal Information
Frequency : 482000 KHz
Service ID : 0401
Multiplex : (TSID 0004, ONID 20fa)
Network : (ID 20fa)
Bit error level 0
Signal Strength 88
Return Enter
OK
Channel
Fine Tune
Signal Information
LNA : On ►
Off
On
Channel
Fine Tune
Signal Information
LNA : Off ►
BN68-01412T-00Eng.indb 26 2008-08-14 �� 2:44:00