Shaw ATLAS PVR Universal Remote Control - Manual (Page 20)

20
RE-ASSIGNING DEVICE KEYS
The Atlas PVR Universal Remote Control can be set up
to control a second device of an already-assigned type.
For example, to have the unit control a TV, a Cable
Converter, and two DVD players, re-assign the unused
AUX key to operate the second DVD Player as follows:
NOTE:
AUX is preset at the factory to control an RCA
VCR. Performing the steps below will over-
write those settings.
The AUX key is now ready to be programmed for your
second DVD player. See “Programming Device Control”
on page 8. To re-assign other device keys, repeat these
and substitute the key sequence using the following
chart:
NOTE:
Only one device can be assigned to an unused
device key at a time.
To re-assign another unused device key, substitute it for
the AUX key above and then perform the sequence. For
example, to re-assign an unused AUD key as a second
4. Press and hold SETUP until the CBL key blinks
twice.
1. On the remote control, press AUX once; it will
blink once. Then press and hold SETUP until
the AUX key blinks twice.
2. Enter 9 9 2. The AUX key will blink twice.
3. Press DVD once, then press AUX once. The AUX
key will blink twice.
To Re-Assign Perform Key Sequence
AUX as 2nd
AUD key AUX ÆSETUPЖ9Ж9Ж2ЖAUDÆAUX
AUX as 2nd
TV key AUX ÆSETUPЖ9Ж9Ж2ЖTVÆAUX
AUX as 2nd
CBL key AUX ÆSETUPЖ9Ж9Ж2ЖCBLÆAUX
AUX back to
AUX AUX ÆSETUPЖ9Ж9Ж2ЖAUXÆAUX
Atlas Shaw M1055FR Rev 1 Eng only.fm Page 20 Wednesday, October 5, 2005 5:28 PM