Saving a macro, Deleting a macro, Using macro attachment – Sony MKS-2010 User Manual

Page 132: Setting a macro attachment

Advertising

Cha

r 6
Ad

nce

d Op

tio

132

Macros

However, the macro assigned to the button is not
executed.

Saving a Macro

Press the [STORE] button or memory recall button [STOR
XX] (where XX is the register number) to save the edited
macro in a register.

To return to the state before editing, without
saving the macro editing results
Press the memory recall button [EXIT] to recall the same
register again. This returns to the state before editing,
without saving the macro editing results.

Deleting a Macro

In the Flexi Pad control block, press the [MCRO]
button.

Press the [BANK SEL] button, turning it on.

Press a memory recall button to select a bank.

Press the [STORE] button, turning it on.

Hold down the [MCRO] button, and then press the the
memory recall button showing the corresponding
register number.

The button you pressed goes off, and this deletes the
macro.
The [STORE] button goes off.

Using Macro Attachment

Macro attachment is a function whereby a macro register
is assigned to a control panel button, linking the execution
of the button function with a macro execution.
Select one of the following three linking modes to make
the macro attachment.
Pre macro: Mode in which the button function is executed

after macro execution has completed

Post macro: Mode in which the macro is executed after

carrying out the button function

Macro only: Mode in which the button function is not

executed, and the macro only is executed

The selection of pre or post macro mode is carried out in
the macro control block. For macro only mode, assign the
selection function to a utility control block button, and
make the selection by pressing the button.

You can assign any one of the 99 macro registers to a
button.

For a button whose function is switched by delegation, you
can make a separate macro attachment for each function.
You can make up to 1000 macro attachment settings.
The macro attachment setting is possible for the following
bus buttons. For button locations, see pages in parentheses.

a) Not found on 1 M/E panel.
b) When you attach macros to buttons that turn independent key transitions

on and off, operations which go from on to off are distinguished from
operations which go from off to on. For example, if you attach a macro to
an operation which uses a button to go from on to off, the macro is not
executed when you press the same button to go from off to on.

c) Not found on 1.5 M/E panel.
d) Excluding the buttons to which one of Device 1 to Device 6, All Stop,

Shuttle, Jog, Rec, Mcro Only Set, Mcro AT with Rate, or Mcro AT with
A/B is assigned.

Setting a macro attachment

See above for the buttons for which a macro attachment
can be set.

Control block

Button

M/E cross-point control block Cross-point buttons

(page

13)

PGM/PST cross-point control
block

Cross-point buttons

(page