Sony MKS-2010 - Manual (Page 19)

C
h
ap
te
r 2
N
a
me
s
an
d
Fu
nc
ti
on
s o
f P
a
rts
19
Control Panel Configuration
See “Setting Transition Rates” (page 69) for more
information about how to specify transition rates.
b DSK PVW (downstream key preview) button
You can press this button, turning it on, to temporarily
switch M/E PVW output (1 M/E panel) or PST output (1.5
M/E panel) to DSK PVW output.
Note
Whether or not this switching function is available
depends on a setting made in the Output Assign menu. For
details, see “Switching M/E PVW or PST output to DSK
PVW output” (page 156).
c DSK independent transition execution section
DSK1 ON, DSK2 ON buttons: Press the [DSK1 ON]
button to cut downstream key 1 in or out (insert or
delete it instantly). The button lights in red when the
key is inserted in program video (final output video).
Otherwise it lights in amber. The [DSK2 ON] button
works in the same way.
AUTO TRANS buttons: Press the corresponding button
to insert or delete downstream key 1 or 2 at the
specified transition rate. The key is mixed to fade in
(insert) or out (delete). The transition begins as soon as
the button is pressed, and the button lights in amber.
When the transition finishes, the button goes out.
See “Setting Transition Rates” (page 69) for more
information about how to specify transition rates.
Flexi Pad Control Block
Use the Flexi Pad control block in the following four
operation modes.
• Effect snapshot mode
• Snapshot mode
• Macro mode
• Transition rate input mode
Depending on the operation mode, this control block
allows you to do the following.
In effect snaphot mode:
• Recall, save, and delete effect snapshots
• Recall effect pattern numbers
In snaphot mode:
• Recall, save, and delete snapshots
• Set snapshot attributes
In macro mode:
Recall (execute), save, delete, and edit macros
In transition rate input mode:
Enter transition rates
a Numeric display
Depending on the operation mode, this shows an effect
pattern number, a bank number, a register number, an
event number, an event total, a pause duration, or a
transition rate, in up to four digits.
In effect snapshot mode: Pattern number
In snapshot mode: Bank number and register number In transition rate input mode: Transition rate
Macro mode
• In macro recall mode: A bank number and register
number
• In macro edit mode: An event number and an event
total
• In pause duration entry mode: A pause duration
EFF/
WIPE
SNAP
SHOT PP/
ALL
BANK
SEL
TRANS
RATE
M/E
MCRO STORE
7 8 9
4 5 6
1 2 3
0 ENTR TC
1 Numeric display
2 Region selection buttons
3 STORE button
4 BANK SEL button
5 Mode selection buttons
6 Memory recall buttons
This figure shows the Flexi Pad control block
in transition rate input mode.