Sony MKS-2010 - Manual (Page 98)

Cha
p
te
r 6
Ad
v
a
nce
d Op
er
a
tio
ns
98
Advanced Effect Operations
To set a relationship between transition
progress and cropping
1
Carry out the procedure in the previous section “To
turn th crop function on” (see page 97).
2
In the Crop menu, press [Crop Trans].
A popup window appears.
3
Select one of the following, as required.
Cut: Cut mode. The crop is unchanged during the
transition, and is released when the transition
completes.
Last 5%: The crop is unchanged until the transition is
95% complete, and is released during the
remaining 5%.
Linear: The cropping is removed linearly through the
whole course of the transition.
4
If you selected “Last 5%” in step 3, specify the dead
zone of the transition by setting “Release Trans” to on
or off.
Off: The transition completes when 95% of the
specified transition duration has elapsed. The crop
is released at the same time.
On: The last 30% of the specified transition duration
is made a transition dead zone. The crop is
released when 95% of the specified duration has
elapsed.
Adding Beveled Edges to Video
This operation can only be carried out on M/E effects.
It is not supported for some patterns.
For more information, refer to “Effect Pattern
Transformations and Modifications” in the Appendix
(separate document).
Light mode and color mode
You can add beveled edges in light mode or color mode.
Light mode: Beveled edges are produced by varying the
brightness at the edges of the video.
Color mode: Beveled edges are produced by adding color
at the edges of the video.
To add beveled edges to video
Note
Beveled edges are added to both channels of 2-channel
effects. They cannot be added to individual channels.
1
Press the [BVLD EDGE] button in the Effect/Wipe
control block, turning it on.
Or, in the Effect/Wipe >M/E Effect >Beveled Edge
menu, turn [Beveled Edge] on.
2
Set the following parameter with knob 1.
a) 100 is 1 /
2
of the full-sized picture.
3
Press [Edge Mode], turning it on.
A popup window appears.
4
Press [Light] to select light mode, or [Color] to select
color mode. (See the previous section “Light mode and
color mode” )
Knob Description Setting values
1 (Width) Width of beveled
edges
0.00 to 100.00
a)
Beveled edges in light mode Beveled edges in color mode