Steamfast SF-407 - Manual (Page 9)

ENGLISH | 9
FILLING WITH WATER
1. Remove Water Tank from main unit.
2. Holding Water Tank upside-down, unscrew and remove Valve Cap by rotating it in a counter-
clockwise direction (FIGURE 7-A).
3. Fill Water Tank with water through Valve Cap hole. Refer to guidelines on side of Water Tank
to fill it with correct amount of water, depending on desired steam time (15, 30, or 45 minutes).
Do not exceed 45 MIN (40 oz / 1180 ml) mark.
NOTE: In order to minimize potential mineral build-up and prolong the life of your
Everyday Fabric Steamer, distilled or de-mineralized water is recommended.
CAUTION: Only water should be used in unit – other chemicals or cleaning agents may
cause internal damage. Do not attempt to substitute any other water tank for the one
designed for use with this unit.
4. Replace Valve Cap by rotating it in a clockwise direction.
5. Place Water Tank back onto main unit (FIGURE 7-B). The sound of water flowing from Water
Tank into Water Reservoir should be audible for a short period of time.
NOTE: Water Tank can be removed and refilled at any time during operation – there is no
need to turn unit off or allow any cooling period.
IMPORTANT: Do not attempt to operate unit with an empty Water Tank.
FIGURE 7
7-A
7-B
Using Your
Everyday Fabric Steamer