Sony TA-MR2ES - Manual (Page 6)

6 US
Getting Started
SONY TA-MR2ES (US) 2-514-603-12(1)
ON
POWER
IN USE
ATTENUATOR L R
+ +
1 2 3 4 *
*To remove the cover
Press either ends of the cover lid to remove the cover.
After you have finished adjusting the ATTENUATOR
L/R, place the cover lid back to its original position.
Front panel of the amplifier
Parts and Controls
1 POWER switch
Press to turn the power on or off.
2 ON indicator
The ON indicator lights up as follows:
– green: the power is on.
– green (flashing three times): the amplifier’s memory
is cleared.
– off: the power is off.
3 IN USE indicator
The IN USE indicator lights up as follows:
– green: the amplifier is in use.
– green (flashing): the IR ID TEST switch is set to
“ON”.
– green (fast flashing): the IR TEST function is in
progress.
– red (flashing): “PROTECTION” mode is turned on.
– off: the amplifier is not in use.
4 ATTENUATOR L/R
Adjusts the maximum volume level of this amplifier to
match the room and the speakers used.
01US03CH1-U.p65 11/30/04, 1:07 PM 6