Sony TA-MR2ES - Manual (Page 9)

9 US
Setting up the amplifier
SONY TA-MR2ES (US) 2-514-603-12(1)
If you install the amplifier in a closed cabinet, install two
small box fans in the cabinet to provide continuous
ventilation.
Note
Attach box fans also if you connect low-impedance speakers (less
than 8 ohms nominal).
Using rack-mount brackets
You can also mount the amplifier into a rack. Make sure
that you measure the space needed before mounting.
1 Install the rack-mount brackets onto the amplifier
with the supplied screws as shown below.
Make sure that the rack-mount brackets are installed
securely.
2 Mount the amplifier into the rack as shown below.
Make sure that the amplifier is installed securely.
Boxer fan (55 CFM)
Rack-mount
bracket
screws
(supplied)
Rack-mount
bracket
screws
(supplied)
+ +
screws
(not supplied) screws
(not supplied)
rack rack
Notes
• Use screws with a minimum diameter of 3/16 inch when you
mount the amplifier into the rack.
• Make sure you check the rack manufacturer’s specifications
before you mount the amplifier into the rack. This is to ensure
mechanical stability.
• This amplifier requires 2U height space when you mount the
amplifier on a standard rack.
01US04CH2-U.p65 11/30/04, 2:44 PM 9