Sharp AR-157E - Manual (Page 15)

13
3
POWER ON
Turn the power switch on the left side of the unit to the "ON" position. The start ( )
indicator will light up.
About the scan head
The scan head lamp remains on constantly when the unit is in the ready condition
(when the start (
) indicator is illuminated).
The unit adjusts the scan head lamp periodically to maintain copying quality. At this
time, the scan head moves automatically. This is normal and does not indicate unit
trouble.
Initial settings of operation panel
When the unit power is on, the operation panel will revert to the initial settings when
the time set with the "Auto clear time" setting (p.22) elapses after a copy or scanner
job is finished, or when the clear (
) key is pressed twice.
The initial settings of the operation panel are shown below.
When copying is begun in this state, the settings in the following table are used.
• The unit will enter a power save mode once the set time has elapsed
without any unit operation. The settings of the power save modes can
be modified. See "USER PROGRAMS" (p.23).
• The unit will return to the initial settings a preset amount of time after
the end of copy or scanner job. The preset amount of time (auto clear
time) can be changed. See "USER PROGRAMS" (p.23).
Copy quantity 1 copy
Exposure adjustment AUTO
Zoom 100%
Tray Paper tray 1
Original to copy (AR-157E) The "Original to copy" indicator does
not illuminate. (One-sided copying only)
"0" is displayed in the display.