Sharp AR-157E - Manual (Page 23)

21
4
Making two-sided copies
1 Place the original(s) on the original table or in the RSPF. (see
"ORIGINAL PLACEMENT" (p.14).
2 Select two-sided copy mode.
A: When copying in a one-sided to two-sided mode:
Use the original to copy key to select the desired one-sided to two-sided
copying mode (Turn on Long Edge or Turn on Short Edge). See the
illustrations on page 20.
B: When copying in the two-sided to two-sided mode:
Use the original to copy key to select the two-sided to two-sided copying
mode. The originals must be set in the RSPF before this mode can be set
in step 3 on page 15.
C: When copying in the two-sided to one-sided mode:
Use the original to copy key to select the two-sided to one-sided copying
mode. The originals must have been set in the RSPF in step 3 on page 15.
3 Select the copy settings. See "SET THE COPY QUANTITY"
(p.16), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p.16),
and "REDUCTION/ENLARGEMENT/ZOOM" (p.18).
Using the original table
If you are using the original table, copying is only possible in one sided to
two-sided mode ("A" above).
1 Press the start ( ) key.
The original is scanned into the unit's memory and the number of the
copy quantity blinks in the display.
2 Place the original that you wish to copy onto the rear side of the
paper, and press the start (
) key again.
Copying begins.
Using the RSPF
Press the start (
) key. Copying begins in the selected two-sided copy mode.
A B C