Shuttle Computer Group XPC SA76 - Manual (Page 25)

2
English

Set Supervisor/User Password
Steps to set supervisor/user password are described as follows:
New Password Setting:
. While pressing <Enter> to set a password, a dialog box appears to
ask you enter a password.
2. Key in a new password. The password can not exceed eight characters.
. System will request you to confirm the new password again.
. When completed, new code takes effect.
No Password Setting:
. If you want to delete the password, just press the <Enter> key
instead of typinga new password. Follow the procedure as ablve.
If You Forget Password:
6. If you forget your password, you must turn off the system and clear
CMOS. Please refer to the tech notes at the end of section two for more
information.

Load Default Settings
When you press <Enter> on this item, you will get a confirmation
dialog box with a message similar to:
Load Default Settings (Y/N) ? N
Pressing 'Y' loads the default values that are factory-set for optimal
performance system operation.