Sony CMT-SX2D - Manual (Page 41)

O
p
tiona
l Com
pone
nts
41 GB
To enhance your system, you can connect optional components. Refer to the operating instructions
provided with each component. North American model is used for illustration purpose.
A DIGITAL OUT (OPTICAL) jack
Use a digital optical cord (square, not supplied)
to connect an amplifier, MD deck or DAT deck
with a digital optical input jack. Sound is then
output when the system function is set to DVD.
By connecting this system to the optical input
jack of the optional amplifier equipped with
Dolby Digital or DTS decoder, you can enjoy
the 5.1 channel sound.
In addition, when the CD or DVD audio is linear
PCM, you can make a digital recording from this
system to an MD deck or DAT deck.
Notes
• When playing MP3 audio tracks, you cannot output
digital audio.
• You can record digital audio from this system only
when DVD function is selected.
• You cannot make a digital recording of a copy
guarded disc using a digital component connected to
this system. Also, playback may not be possible
depending on the connected component.
• When you connect a component that does not support
Dolby Digital or DTS to the DIGITAL OUT
(OPTICAL) jack and output a Dolby Digital or DTS
bit stream, noise may be heard from the connected
component.
B TV IN L/R jacks
Use audio cords (not supplied) to connect an
optional analog component (TV or VCR, etc.) to
these jacks. You can then record or listen to from
the component through this system.
Hooking up optional components
Amplifier or MD deck
From the audio output jack
of the connected
component
TV or VCR, etc.
To the digital input jack of
the digital component