Sony CMT-SX2D - Manual (Page 48)

48 GB
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1
Remove the disc if it is loaded.
2
Disconnect the power cord.
3
Reconnect the power cord.
4
Press ?/1 to turn on the system.
5
Press DVD NX to switch the function to
DVD and make sure that “NO DISC” is
displayed.
6
Press x, PLAY MODE and DVD NX at the
same time.
The system is reset to the factory settings except
for DVD settings. You should set the settings
you made, such as the preset stations, clock, and
timer.
To return the DVD setup to the
default settings*, perform reset
as follows:
The operation can only be set using the TV
screen.
1
Press DISPLAY in stop mode.
2
Press < or , repeatedly to select “Reset,”
then press ENTER.
3
Press < or , repeatedly to select “YES,”
then press ENTER.
It takes a few seconds to complete. Do not
press ?/1 when resetting the system.
* Except for Rating (Parental Control) settings
One of the following messages may appear or
flash in the display during operation.
DVD/VIDEO CD/CD/MP3/JPEG
CAN’T PLAY
• A disc that cannot be played was inserted.
• A disc with an unsupported Region code was
inserted.
NO DISC
There is no disc in the unit.
NOT IN USE
You pressed an invalid button.
Tape
NO TAB
You cannot record the tape because the tab has been
removed from the cassette.
NO TAPE
There is no tape in the tape deck.
TAPE ERR
A malfunction of the tape deck has occurred.
Messages