SpectraLink 150 M3 MCU - Manual (Page 39)

SpectraLink Corporation Link WTS Installation and Operation
Part Number: 72-0075-01-C-W.doc Page 28
mainly on.
3. Press the DEL/ENTER button. The line indicator LED for the selected line will be
off with a short on flash.
4. Register the new Wireless Telephone or return the mode switch to the NORM
position.
6.4 Program Wireless Telephone Features
PBX and Key Systems provide users with special features such as hold, trans fer,
conference, camp on, and speed dial. These features can be accessed via the Wireless
Telephone, but the telephone system or Link 150 M3 MCU must be programmed to
allow access to these features from the Wireless Telephone. For information on
programming the switch to operate with the Wireless Telephones, refer to LinkPlus
Digital Integration Guide (PN 72-0070-00).
•
If the Link 150 M3 MCU is connected to your telephone system via analog lines,
refer to Appendix B: Program Analog Features.
•
If your Link 150 M3 MCU is connected to a digital key telephone system or PBX,
refer to the section of the LinkPlus Digital Integration Guide document that deals
specifically with your brand of telephone system.
6.5 Test Wireless Telephones
Verify proper registration and operation of each Wireless Telephone by performing the
following steps.
1. Press the START key on each Wireless Telephone. The extension number should
clear and you should hear dial tone. On some digital systems, depending on how
the telephone system is programmed, you may have to select a line to get dial
tone.
2. Place a call to each Wireless Telephone to verify ring, answer, clear transmit, and
clear receive audio.
3. Verify all programmed features on each Wireless Telephone.
4. Press the END key. The line indictor should turn off.