SpectraLink 150 M3 MCU - Manual (Page 54)

SpectraLink Corporation Link WTS Installation and Operation
Part Number: 72-0075-01-C-W.doc Page 43
12.3 Program Macro Codes
Functions are defined by placing an Administrative Call using the Administrative
Wireless Telephone (registered to Line 2 of MCU 1). Follow these steps to place an
administrative call and define functions.
! !
In multi- unit installations, be sure all MCUs are properly connected to one
another before making an administrative call.
1. On the MCU that displays a box ID of 1 , move the mode switch to the ADMIN
position.
2. Press the START key on the administrative Wireless Telephone (the Wireless
Telephone registered to MCU 1, line 2). This is the only Wireless Telephone
enabled to make the administration call.
3. When you hear a steady tone (not a dial tone), the Wireless Telephone is in an
administrative call and is ready to program.
4. Press the FCN key followed by the key strokes used to access the function. Valid
keys are 0-9, *,#, START (flash), and FCN (pause). Note that FCN + 1 is reserved
for Mute.
5. Press the function key sequence to be programmed. If a key sequence is
incorrectly entered, go to the next step.
6. Press the END key to complete the programming of the function. Repeat steps 4-
7 for all remaining functions or to reprogram a function to correct an input error.
7. Return the mode switch to the NORM position.
The line LEDs now indicate line status and the administrative Wireless Telephone can
now place calls normally.