Samsung HT-BD2S - Manual (Page 49)

system upgrade

SYSTEM InFORMATIOn
When the fi rmware upgrade is done, check the fi rmware details by following the steps below.
With the unit in Stop mode, press the MEnU button.
Press the $% buttons to select Setup, then press the
EnTER or + button.
Press the $% buttons to select System Upgrade, then
press the EnTER or + button.
Press the $% buttons to select System Information,
then press the EnTER or + button.
You can see detailed information about the current
fi rmware.
Press the EnTER button to select OK.
System Upgrade menu will be displayed.
nETWORK SETUP
In some rare cases, the fi rmware upgrade may not succeed.
If this occurs, you may need to set up your IP address, Subnet, Mask, Gateway and DNS by following the steps
below.
To setup, follow steps 1 and 3 above
Press the $% buttons to select network setup, then
press the EnTER or + button.
You will see a menu that allows you to make network
settings.
Press the $% buttons to select DHCP, then press the
EnTER button.
If DHCP is set to On, you can't select IP Address, Subnet Mask or Gateway.
If DNS is set to Automatic, you can’t select Primary/ Secondary DNS.
1.
.
3.
.
•
5.
•
.
•
5.
M


no Disc
Photo
Setup System Upgrade
network Setup
Upgrade Start
System Information
HDMI Setup
Parental Setup
no Disc
Photo
Setup System Upgrade
network Setup
Upgrade Start
System Information
HDMI Setup
Parental Setup
OK
System Information
S/W: xxxxxx_xx_xxx
Region:B/02(BD/DVD)
no Disc
Photo
Setup System Upgrade
Upgrade Start
Network Setup
HDMI Setup
Parental Setup System Information
no Disc
Photo
Setup System Upgrade
Upgrade Start
Network Setup
HDMI Setup
Parental Setup System Information
network Setup
s SELECT r RETURN
Save Cancel
DHCP : On
IP Address : 000 . 000 . 000 . 000
Subnet Mask : 255 . 255 . 255 . 000
gateway : 000 . 000 . 000 . 000
DnS : Automatic
Primary DnS : 000 . 000 . 000 . 000
Secondary DnS : 000 . 000 . 000 . 000
HT-BD2_XAA_0210.indd 48 2008-02-11 �� 11:28:45