Saitek P3000 User Manual
Page 5
INSTALLATION FOR USERS OF WINDOWS® 2000
A) Drivers Only For Typical Users
1
With your computer switched on, close down any programs that are currently running and
insert the Saitek Smart Technology CD into your CD-ROM drive.
2
When the Introduction Screen appears, click Install Software to continue.
3
When the Welcome screen appears, click Next to continue. (If the CD does not run
automatically, select Start from the Windows® Taskbar, then Run and type D:\Setup.exe and
click OK - where D:\ is letter of your CD-ROM drive).
4
After reading the Disclaimer, select the I accept the terms of the Disclaimer option and click
Next to continue.
5
At the Device Driver Installation screen, click on Next and follow the on-screen instructions.
6
When prompted, plug your controller’s USB connector into your computer, then click on
Configure.
7
When the Controller Properties screen appears, click Next to view the Test screen.
8
Now try out all your controller’s buttons and controls to show that it is working properly. When
you have finished, click OK.
9
At the Programming Software screen, select Typical User and click Next.
10 At the Registration screen, select Register and follow the on-screen instructions or select
Register Later and click Next.
11
Click on Finish to complete the installation.
B) Drivers and Programming Software For Advanced Users
1
Follow points 1 – 7 of the install procedure in A), then at the Programming Software screen,
select Advanced User and click Next.
2
At the Programmable Controller Drivers screen, click Update and follow the on-screen
instructions.
3
Then at the Installation of programming software successful screen, click Next.
4
At the Registration screen, select Register and follow the on-screen instructions or select
Register Later and click Next.
5
Upon completion of the installation, you have the option to Run Profile Editor, which will give
you a view of the 3D programming environment. If you do not wish to see the Profile Editor at
this point, just uncheck the box and click on Finish to complete the installation.
P3000 Micro RoW Manual.qxd 30/01/2004 08:50 Page 5