Sharp LL-171G - Manual (Page 13)

14
When connecting using a separately sold
2-input cable [LL-171G]
The separately sold 2-input cable (model name:
NL-C03J) enables connection between the DVI-I
input terminal on the monitor and the two
computers. (One analog and one digital
connection.)
1. Connect the 2-input cable to the DVI-I input
terminal of the monitor.
2. Connect the accessory or commercially
available analog signal cable and the accessory
digital signal cable to the 2-input cable.
- When using commercially available analog
signal cable, both ends should be mini D-sub
15 pin.
3. Connect each signal cable to the computers.
- Paying attention to connector direction, firmly
insert the signal cable into the connector, and
then tighten the screws at both sides.
Connecting the monitor and turning the monitor on and off
Digital RGB
output terminal
Digital signal cable
2-input cable
(purchased
separately)
Mini D-sub15 pin
DVI-D24 pin
Analog RGB
output terminal
Analog signal
cable
DVI-I input terminal
(INPUT-2)
Notes:
- When using the 2-input cable, set the
connecting input terminal [INPUT-2] to [2LINES]
under the MODE SELECT-2 Menu. (p.22)
- The monitor connected to the 2-input cable by
analog connection may not be automatically
recognized and setup under Plug & Play.
Perform storage of setup information manually.
(p.28)
Connect the accessory audio cable
When the accessory audio cable is connected to
the audio output terminal of the computer, the
sound of the connected computer is output from
the monitor speakers. You can also use the
headphone jack of the display.
Audio output terminal
Audio cable
Audio input terminal
171AG_gb.P65 12/4/2003, 1:14 PM 14