Woodstock International Fox Fense W1410 - Manual (Page 18)

Shop Fox ® Fence -17-
Figure 25. Fence stop installation.
H. FENCE STOP
Once the fence has been adjusted, install the fence
stop through the hole located near the end of the
scale on the front rail. Figure 25. This prevents the
fence from accidentally being rolled off the end of
the rails.
Figure 24. Location of shims.
Step 4.
Reinstall the fence on the rails and slide it along
slowly, checking to make sure that neither the roll-
ers nor the upper clamp jaw contact the scale.
Step 5.
Note which side of the indicator the hairline is
imprinted on. Orient the indicator with the hairline
mark face down against the front rail. The hairline
is imprinted off center to simplify adjustment of
the indicator if the fence is faced with 3 ⁄
4
'' material.
If the fence is not faced, place the hairline off cen-
ter to the right as viewed from above. If the fence
is faced, position the hairline to the left.
Step 6.
The indicator can be shimmed downward for bet-
ter reading accuracy. This eliminates any shifting
that may seem to occur between the hairline and
the marks on the scale when viewed from any
position not directly overhead. Figure 24.
Step 7.
To fine tune the position of the hairline indicator,
make a test cut and adjust the indicator to corre-
spond with the actual width of the test board. This
method accounts for any vibration or wobble that
may be present in the spinning blade. This proce-
dure must be repeated every time the saw blade is
changed to maintain accuracy.