Woodstock International Fox Fense W1410 - Manual (Page 8)

Shop Fox ® Fence -7-
Figure 4. Mounting the rear rail.
Step 8.
The distance between the front and back rail
should be 27'' ± 1 ⁄
4
''. Add or remove washers to
achieve this measurement. If your measurement
does not fall within this range, refer to Section V
on page 20 for further instruction.
Step 9.
Measure the distance between both ends of the
rails to determine if they are parallel. The differ-
ence between the two ends of the rails should be
no more than ± 1 ⁄
8
".
Note: relative parallelism between the ends of the
rails is not critical to the accuracy of the fence, but
will prevent the unlocked fence from moving by
itself in the direction of the taper. Extra washers
may be added or removed from between the table
and back rail to achieve parallelism.
Step 10.
Mount the cross brace to the end of the rails using
the 3 ⁄
8
-16 x 1'' Hex Bolts and Flat Washers provid-
ed. Leave the bolt in the middle of the brace loose
until the bolts at the ends of the brace are tight.