Setting the operating temperature, Indicator lights – Smeg CV 270 AP User Manual

Page 9

Advertising
background image

en

en

1 = Lowest cooling setting (Warmest setting)
4 = Highest cooling setting (Coldest setting)

(Or)

Min. = Lowest cooling setting
(Warmest setting)
Max. = Highest cooling setting
(Coldest setting)

Please choose the setting according to the
desired temperature.

The interior temperature also depends on
ambient temperature, the frequency with which
the door is opened and the amount of foods
kept inside.
Frequently opening the door causes the interior
temperature to rise.
For this reason, it is recommended to close
the door again as soon as possible after use.

The normal storage temperature of your
appliance should be -18 °C (0 °F). If the
thermostat knob is turned counter clockwise
from position 1, the appliance will be switched
off and “click” sound will be heard. Lower
temperatures can be obtained by adjusting
the thermostat knob towards Position 4.
We recommend checking the temperature
with a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember to take the reading
immediately since the thermometer
temperature will rise very rapidly after you
remove it from the freezer.

Setting the operating
temperature

(Fig. 2)

The operating temperature is regulated by the
temperature control.

4

Warm

Cold

1 2 3 4

(Or) Min.

Max.

Indicator lights

There are three coloured indicator lights located
inside the appliance which show the operating
mode of the freezer (Fig. 2).

Amber Indicator (1)
Illuminates when the fast-freeze switch (4) is
turned on and stays on until the fast freeze
operation is deactivated manually.
Fast-freeze operation is for freezing fresh food
(see Freezing Fresh Food section).

Green Indicator (2)
Illuminates when the appliance is connected
to the mains and will glow as long as there is
electricity present. The green indicator does
not give any indication of the temperature
inside the freezer.

Red Indicator (3)
Illuminates
a. When the appliance is first switched on,
and will stay on until the pre-set temperature
has been attained.
b. If the appliance is overloaded with fresh
food.
c. If the appliance door is left open accidentally.

Thermostat knob (5)
The thermostat knob is located on the indicator
light frame.

Important:
When you press the fast-freeze switch or adjust
the set temperature, there may be a short
delay before the compressor starts to operate.
This is normal and not a compressor fault.

Advertising
This manual is related to the following products: