Sony DSM-T1 - Manual (Page 12)

12
Menu Setup
Menu List
Menu items are classified as one of the following
categories:
• Basic items (01~ and 10~)
• Items about an optional board in the IN1 section on
the rear panel (40~)
• Items about an optional board in the IN2 section on
the rear panel (50~)
• Items about the front panel (80~)
• Items about the saving and recalling functions (90~)
The parameters in bold print are factory settings.
Item number Item Parameter Function
01 INPUT SELECT
02 REF SELECT
03 VIDEO STD
08 PASSWORD
11 FREQ BW
12 FEC RATE
14 IF FREQ
15 IF OUT LEVEL
16 CARRIER
41 IN1 SDI AUDIO
42 IN1 EMPHASIS
IN1
IN2
IN1&IN2
EXT
IN1
IN2
525
625
OFF
ON 0000 0001
:
FFFF FFFF
36 MHz
18 MHz
7/8
3/4
140 MHz
70 MHz
0dB..-10dB
<-10dB
-20dB
QPSK
OFF
CW
SDI
AES/EBU
OFF
ON
Selects either or both IN 1 or IN 2 section input signals to be
transmitted from the IF OUT connector.
IN1: The input signals from the optional board in the IN
1
section are transmitted.
IN2: The input signals from the optional board in the IN
2
section are transmitted.
IN1&IN2: The input signals from both optional boards in the
IN
1 and IN 2 sections are transmitted.
Selects the reference signals.
EXT: Video signals from the REF IN connector
IN1: Video signals from the input connector of the optional board
in the IN
1 section.
IN2: Video signals from the input connector of the optional board
in the IN
2 section.
Selects the broadcasting standard for which the unit is set up.
525: 525 standard
625: 625 standard
Turns the password function on or off. When “ON” is selected,
set the password.
OFF: The DSM-R1 outputs normal video/audio signals
regardless of the password of the DSM-R1.
ON: Sets an 8 digits password. If the password of the unit does
not match that of the DSM-R1, no video/audio signals will be
output from the DSM-R1.
Selects the frequency bandwidth.
Selects the Forward Error Correction rate.
Selects the output carrier frequency of the IF OUT connector.
Selects the output level of the IF OUT connector.
In 0dB..-10dB mode, the level can be set from 0dB to
-10dB in 1dB steps. In <-10dB mode, the level can be set from
-10dB to -20dB, but the displayed parameter is <-10dB.
Selects whether or not to modulate the IF output signals.
QPSK: Outputs QPSK modulated wave
OFF: Outputs no IF signals
CW: Outputs continuous (non modulated) wave
Selects the digital audio input signals if the BKSM-T102 SDI
Input Board is installed in the IN
1 section of the unit.
SDI: Digital audio signals in SDI format
AES/EBU: Digital audio signals in AES/EBU format
Turns the audio emphasis function on or off if the BKSM-T103
Analog Input Board is installed in the IN
1 section of the unit.