Sony DSM-T1 - Manual (Page 14)

14
SDTI
DIGITAL INPUT IN
AUDIO (AES/EBU) SDI
CH 1/2 CH 3/4
DIGITAL INPUT IN
REF IN SPARE BREAKER ⁄ AC IN
IF OUT MONITOR
AUDIO VIDEO
ANALOG INPUT IN
CH1 CH2
Low noise block converter
High power amplifier
Up converter
Satellite link
SDTI(SX)
equipment
SDI
equipment
Analog
equipment
BKSM-R103
Analog Output
Board
BKSM-R102
SDI Output
Board
BKSM-R101
SDTI(SX) Output
Board
DSM-R1 Digital Satellite Demodulator
Signal generator
(Sony Tektronix TSG-170A for the
NTSC broadcasting standard, Sony
Tektronix TSG-271 for the PAL
broadcasting standard, etc.)
Spectrum analyser
AC power cord
to a wall outlet
DNW-A100/A100P
Digital Video Hybrid Recorder, etc. BVW-75/75P Video Cassette
Recorder, etc.
DVW-A500/A500P Digital Video Cassette Recorder,
DNW-A100/A100P Digital Video Hybrid Recorder,
DNW-7/7P Digital Camcorder with the CA-701 SDI Adaptor, etc.
Any two
IF OUT REF IN
to test signal output
IF MONITOR
⁄ AC IN
AUDIO CH2
AUDIO CH1
VIDEO
SDI
to SDI output
SDTI
to SDTI(SX) output
BKSM-T103
Analog Input Board
BKSM-T102
SDI Input Board
BKSM-T101
SDTI(SX) Input Board
Rear
to monitor input
to analog
composite video
output to analog
audio output
(channel 1 or 3)
to analog
audio output
(channel 2 or 4)
When using the 3pin XLR connector
to signal output
to reference
signal input
Connection
The illustration below shows a typical connection of
the unit for digital Satellite News Gathering.
• There are two kinds of connectors on the BKSM-T103
Analog Input Board, 3-pin XLR or 5-pin XLR connector.
When using the 5-pin XLR connector, see also the next
page.
• For more information about connecting external
equipment, refer to the equipment operation manuals.