Sony TA-FA777ES - Manual (Page 4)

Getting Started
4 GB
Hookup Overview
The amplifier allows you to connect and control the
following audio components. Follow the hookup
procedure indicated for each component that you want
to connect.
To learn the location and name of each jack, see ”Rear
Panel Descriptions” on page 9.
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the mains leads of the various
components until all connections are completed.
• Use the audio connecting cords supplied with each
component for hooking up with the amplifier.
Purchase and use optionally available cords as
required.
• Be sure to make connections firmly to prevent hum
and noise.
• When connecting an audio connecting cord, be sure
to match the R(right) and L(left) jacks of the
amplifier to the R and L jacks on the other
components.
Audio Component Hookups
Overview
Here you learn how to connect your audio components
to the amplifier.
Tape deck DAT deck
MD deck
Tuner
Super audio
CD/CD player
Speaker (L) Speaker (R)
Active speaker
etc.
What cords will I need?
Audio connecting cords (not supplied) (1 for each
component and turntable; 2 for each tape deck, DAT deck, or
MD deck)
Hookups
The arrow ç indicates signal flow.
Super audio CD/CD player
Amplifier Super audio CD/CD player
Ç L
R
L
R
OUTPUT
LINE
SACD/CD
IN
Connecting a Super audio CD/CD player with
balanced connectors
When the player is far from the amplifier, use balanced
cables to minimize interference from external noise.
Amplifier Super audio CD/CD player
After connecting the balanced cables, set AUX INPUT to
BALANCED.
c
AUX INPUT
BALANCED
UNBALANCED
Note
Do not use both balanced and unbalanced output connectors
at the same time. If you do, degradation or lack of sound
output may occur.
Tuner
Amplifier Tuner
White (L) White (L)
Red (R) Red (R)
Press tab to disconnect.
Balanced cable (Canon XLR-3-32
or equivalent) (not supplied)
Align arrow with tab.
1: GROUND
2: HOT(+)
3: COLD(–)
CONNECTION
ASSIGNMENT
1
2
3
Ç
AUX INPUT BALANCED OUTPUT
L
R
L
R
Ç L
R
OUTPUT
LINE
L
R
TUNER
IN
ON
PHONO
TAPE 3
TAPE 2 / MD
TAPE 1 / DAT
AUX
TUNER
SACD/CD
• AUX RECOUT SELECTOR
• •
•
• • •
BALANCE
• • LEFT RIGHT
• 0 TREBLE
• •
•
• • • •
•
• •
–10 +10
• 0 BASS
• •
•
• • • •
•
• •
–10 +10
• ON SPEAKERS
•
TONE
OFF
OFF (AUX, CD, TUNER, PHONO)
PHONES
U
TAPE2 c 1/3 TAPE1 c 2/3 SACD/CD
TUNER
PHONO
REC OUT
SOURCE DIRECT
INPUT SELECTOR
ATTENUATOR
dB
15 13 11
9
7
5
3
1 0 80
66
55
46
36
28
21
•
PRE OUT TAPE2/MD
PHONO
SACD/CD
TUNER AUX
TAPE3 TAPE1/DAT
2 3
1
Turntable