Woodstock M1113 - Manual (Page 20)

-18-
M1113 18" Wood/Metal Bandsaw
SE
TU
P
Once the assembly is complete, test run the machine to
make sure it runs properly for regular operations.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety dis-
abling mechanism on the switch works correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review Troubleshooting on Page 46.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To test run the machine, do these steps:
1. Connect the machine to the power source.
2. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is setup properly.
3. Ensure all tools and objects used during setup are
cleared away from the machine.
4. Press the green ON button on the power switch,
then press the ON key on the motor switch to start
the machine.
— When operating correctly, the machine runs
smoothly with little or vibration or rubbing noise.
— Investigate and correct strange noises or vibrations
before operating the machine further. Always dis-
connect the machine from power when investigat-
ing or correcting potential problems.
5. Turn the machine OFF.
6. Insert the switch disabling pin through the green ON
button, as shown in Figure 22.
7. Press the ON button to test the disabling feature on
the switch.
— If the machine does not start, the switch disabling
feature is working as designed.
— If the machine starts, immediately stop the
machine or disconnect the power. The switch dis-
abling feature is not working correctly. Call Tech
Support for help.
Test Run
Figure 22. Switch disabling pin inserted
into ON button.
Projectiles thrown from the machine
could cause serious eye injury. Wear
safety glasses to reduce the risk of
injury.
DO NOT investigate problems or adjust
the machine while it is running. Wait
until the machine is turned OFF,
unplugged and all working parts
have come to a complete stop before
proceeding!
Switch
Disabling Pin