Siemens WTXD5522UC - Manual (Page 19)

19
Choose a time program
1. Rotate program selector to time
dry/.... min.".
- Select the drying time from the
following table according to the
laundry type.
Laundry type Required drying time
Thin woolen pullover
(approx. 0,8lbs/350 g) 80 min.
(e.g. 60 + 20 min)
Thick woolen pullover
(approx. 1,9lbs/850 g) 90-120 min.
(e.g. 60 + 40 min)
Skirt 60-90 min.
Trousers 60-90 min.
Small items
(e.g. gloves) 30 min.
Shoes 30 min.
2. Press the start/stop" button. The
start/stop" indicator light
illuminates.
3. If the item of clothing still contains
residual moisture after the
indicated drying time:
q Fold the item of clothing so that
the damp parts are on the
outside.
q Restart the program and reduce
the drying duration depending
on the degree of residual
moisture.
4. After drying, spread out the
laundry at air for approx. 15 min.
(shoes for approx. 30 min.).
5. Remove the lint filter.
6. Take the dryer rack out of the
drum.
7. ReĆinsert the lint filter.
Cleaning and care
Cleaning the dryer
d WARNING d
TO AVOID
RISK OF EXPLOSION!
Never use solvents or highly
flammable liquids for cleaning.
ATTENTION
Incorrect cleaning may damage
the dryer. Do not spray with a
water jet. Do not use scouring
agents or allĆpurpose cleaners.
Do not use steam cleaners.
Wipe the housing and fascia with a soft
cloth and soapy water only.
Wipe the drum, door seal and inside of
the door with a damp cloth only.
Cleaning the lint filter
A dirty filter extends the drying time and
increases energy consumption.
The filter should be cleaned before and
after each drying process.
If a warning signal and an E01 warning
message are emitted during a drying
program, clean the filter immediately
and check the exhaust duct.
i The program interrupts
automatically.
1. Switch off the dryer. Program
selector to off".
d CAUTION
The inside of the door heats up
during the drying process.
2. Open the door.
3. Remove the lint filter.
4. Remove lint by stroking your hand
over the filter.
The filter should be lightly scrubbed
twice a year with warm soapy water.
The filter is cleaned when it no longer
holds water. The filter must be dried
thoroughly before being replaced.
5. Insert the filter.
6. Close the door.