Connections, Aux in 2 – Samsung HT-TZ215 EN User Manual
Page 13
24
connections
25
ENG
●
CONNECTIONS
●
CONNECTIONS
Do not insert any other card except the TX card dedicated to the product.
If a different TX card is used, the product may be damaged or the card may not be
removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the DVD Player is turned off. Inserting the card when it is turned
on may cause a problem.
If the TX Card is inserted and wireless receiving module setting is complete, sound is not
output from the Rear Speaker connectors on the main unit.
The wireless receiving antenna is built into the wireless receiver module. Keep the unit
away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver
module location is clear of any obstructions.
If no sound is heard from the wireless rear speakers, switch the mode to DVD 5.1
channel or Dolby ProLogic II .
In 2-CH mode, no sound will be heard from the wireless rear speakers.
M
Place the wireless receiver module at the rear of the listening position. If the wireless
receiver module is too close to the main unit, some sound interruption may be heard due
to interference.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment,
or any other device that uses the same frequency (5.8GHz) near the system, some sound
interruption may be heard due to interference.
The transmission distance from the main unit to the wireless receiving module is about 33
feet (10m), but may vary depending on your operating environment. If a steel-concrete wall
or metallic wall is between the main unit and the wireless receiver module, the system may
not operate at all, because the radio wave cannot penetrate metal.
This product(HT-Z310/TZ312/TZ315) is also compatible with the wireless receiver module
SWA-3000.
HT-Z210/TZ212/TZ215 doesn't support wireless receivng function.
HT-Z210/TZ212/TZ215 doesn't support Bluetooth function.
CONNECTING THE VIDEO OUT TO YOUR TV
Choose one of the four methods for connecting to a TV.
AUX IN 2
AUX IN 2
METHOD4
(supplied)
METHOD1
METHOD2
METHOD3
METHOD 1 : HDMI(optional)
Connect the HDMI cable from the HDMI OUT jack on the back of the DVD Player to the HDMI IN jack
on your TV.
METHOD 2 : Component Video
If your television is equipped with Component Video inputs, connect a Component video cable(not
supplied) from the Component Video Output (Pr, Pb and Y) jacks on the back of the DVD Player to the
Component Video Input jacks on your TV.
COMPONENT SELECT Function
With the main unit turned off, press and hold the
1.
Number 8 (COMPONENT SEL.) button on the
remote control for over 5 seconds.
<Y Pb Pr> or <RGB> will appear in the display.
•
Press the
2.
Number 8 (COMPONENT SEL.) button shortly to select <Y Pb Pr> to set the main unit to
COMPONENT mode.