System setup, Setting the audio, Setting the drc (dynamic range compression) – Samsung HT-TZ215 EN User Manual
Page 30: Setting the av sync, Setting the hdmi audio
58
system setup
59
ENG
●
SYSTEM SETUP
●
SYSTEM SETUP
SETTING THE AUDIO
Press the SOUND EDIT button and then press the Cursor
W,X button.
Adjusting Front/Rear Speaker Balance
You can select between 00, -06, and OFF.
The volume decreases as you move closer to –6.
Adjusting Center/Rear/Subwoofer Speaker Level
The volume level can be adjusted in steps from +6dB to –6dB.
The sound gets louder as you move closer to +6dB and quieter as you get closer to -6dB.
SETTING THE DRC (DYNAMIC RANGE COMPRESSION)
This feature balances the range between the loudest and quietest sounds. You can use this function to enjoy Dolby
Digital sound when watching movies at low volume at night.
In Stop mode, press the
1.
MENU button.
Press the Cursor
2.
▼ button to move to Audio and then press the
ENTER button.
Press the Cursor
3.
▼ button to move to DRC and then press the
ENTER button.
Press the Cursor
4.
S,T to adjust the DRC.
When the Cursor
•
S button is pressed, the effect is greater, and
when the Cursor
T button is pressed, the effect is smaller.
d Press the RETURN button to return to the previous level.
d Press the EXIT button to exit the setup screen.
Manually Adjusting the Speaker Volume and Balance with the SOUND EDIT Button.
RETURN
MOVE
ENTER
EXIT
CHANGE
EXIT
RETURN
SETTING THE AV SYNC
Video may look slower than the audio if it is connected to a digital TV. If this occurs, adjust the audio delay time to
match the video.
In Stop mode, press the
1.
MENU button.
Press the Cursor
2.
▼ button to move to Audio and then press the
ENTER button.
Press the Cursor
3.
▼ button to move to AV-SYNC and then press
the ENTER button.
Press the Cursor
4.
S,T button to select the AV-SYNC Delay Time
and then press the ENTER button.
You can set the audio delay time between 0 ms and 300 ms. Set
•
it to the optimal status.
d Press the RETURN button to return to the previous level.
d Press the EXIT button to exit the setup screen.
SETTING THE HDMI AUDIO
(optional)
The audio signals transmitted over the HDMI Cable can be toggled ON/OFF.
In Stop mode, press the
1.
MENU button.
Press the Cursor
2.
T button to move to Audio and then press the
ENTER button.
Press the Cursor
3.
T button to move to HDMI AUDIO and then
press the ENTER button.
Press the Cursor
4.
S,T button to select ON or OFF and then press
the ENTER button.
• ON : Both video and audio signals are transmitted over the HDMI
connection cable, and audio is output through your
TV speakers only.
• OFF : Video is transmitted over the HDMI connection cable only,
and audio is output through the home cinema speakers only.
d Press the RETURN button to return to the previous level.
d Press the EXIT button to exit the setup screen.
M
The default setting of this function is HDMI AUDIO OFF.
HDMI AUDIO is automatically down-mixed to 2ch for TV speakers.
MOVE
ENTER
EXIT
RETURN
MOVE
SELECT
EXIT
RETURN
MOVE
ENTER
EXIT
RETURN
MOVE
SELECT
EXIT
RETURN