Samsung SVD-4600 - Manual (Page 9)

COLOR CCD CAMERA User Guide 16 COLOR CCD CAMERA User Guide 17
Operating Your Camera
AGC (AUTO GAIN CONTROL) :
The higher the gain level, the brighter the screen - but the higher the noise.
- OFF : Deactivates the AGC function.
- LOW : Allows automatic gain control from 5.3dB to 30dB.
- HIGH : Allows automatic gain control from 5.3dB to 42dB.
SENS-UP :
When it is night or dark, the camera automatically detects the light level and
maintains a clear picture if this mode is activated.
- OFF : Deactivates the SENS-UP function.
- AUTO : Activates the SENS-UP function.
RETURN :
Select this to save the changes in the EXPOSURE menu and return to the SETUP menu.
• If you press the Function Setup switch in ‘AUTO’ mode, You can adjust brightness by
increasing or decreasing the shutter speed. (x2 ~ x256)
• Note that the higher the zoom level, the brighter the screen, but the more likely it is
that an after-image will appear.
• Although Noise, Spots, and Whitish symptoms may occur in SENS-UP operation
when the zoom level is increased, this is normal.
Notes
Use the White Balance function to adjust the screen color.
1. When the SETUP menu screen is displayed, select ‘White Bal.’ by using the
Function Setup switch so that the arrow indicates ‘White Bal.’ .
2. Select a desired mode using the Function Setup switch.
＊ Select one of the following 5 modes, as appropriate for your purpose.
ATW : Select this when the color temperature is between 1,800ºK and 10,500ºK
INDOOR : Select this when the color temperature is between 4,500ºK and 8,500ºK.
OUTDOOR : Select this when the color temperature is between 1,800ºK and 10,500ºK.
(sodium light inclusion)
AWC→SET : To find the optimal setting for the current luminance environment in this
mode, set the point the camera towards a sheet of white paper and press
the Function Setup switch. If the environment changes, readjust it.
White Balance (White Bal.)
MANUAL : Select this to fine-tune White Balance
manually. Set White Balance first by using the
ATW or AWC mode. After that switch to
MANUAL mode, fine-tune the White Balance
and then press the Function Setup switch.
• White Balance may not work properly under the following conditions. In this case
select the AWC mode.
❶ …… When the color temperature of environment surrounding the subject is out of the
control range (e.g. clear sky, or sunset)
2 … When the ambient illumination of the subject is dim.
3 … If the camera is directed towards a fluorescent light or is installed in a place
where illumination changes dramatically, the White Balance operation may
become unstable.
Notes
MAIN SETUP
1.LENS DC
2.EXPOSURE
3.WHITE BAL ATW
4.BACKLIGHT OFF