Samsung SIR-T151 - Manual (Page 11)

1.2
CHAPTER ONE
Connecting The Set-Top Box
Rear Panel Jacks
1 1
Œ DTV Air (75 Ω )
Connect the antenna here. Connect cable in the event
that a local cable provider is passing through 8VSB on
their system.
´ DOLBY DIGITAL OUTPUT (Coaxial)
Connect this terminal to the digital audio input of a TV
set.
ˇ DTV OUT COMPONENT (Y, P
B
, P
R
format)
Connect to the Y-P
B
-P
R
digital video input of a digital-com-
patible TV set (or the Y-P
B
-P
R
inputs of some other video
component).
¨ Lt/Rt ANALOG-AUDIO OUTPUTS
Connect these terminals to the analog audio inputs of a
TV set (i.e., to a TV that has jacks for L/R inputs).
Or, connect these terminals to the L/R inputs of a sepa-
rate audio component.
ˆ VIDEO OUT
If your TV or monitor has Audio/Video capability, connect
this jack to the AV Input jack on your TV or monitor using
an Audio/Video cable.
Use this output for conventional TV sets that do not have
S-Video or component video inputs.
Ø S-VIDEO OUTPUT
Provides good picture quality. If your TV or monitor has
S-Video capability, use this jack along with the
Audio/Video jacks to connect the Set-Top Box.
Use this output for conventional TV sets that have an S-
Video input but no component video inputs.
∏ DOLBY DIGITAL OUT (fiber optic connector)
Connect this terminal to the digital audio input of a TV set
(i.e., to a TV set that has a fiber-optic connector for digi-
tal audio). Or, connect this terminal to the digital-audio
input of a separate component (i.e., AC3-AMP ...).
” RESOLUTION SELECT
Switches between 1080i (interlaced scanning), 720p
(progressive scanning), 480p (progressive scanning), and
480i (interlaced scanning) formats.
Switches the DTV Component outputs to the following for-
mats:
• 1080i (Interlaced Scanning)
Use this setting for an HDTV Ready 16 X 9
(WIDESCREEN) aspect ratio TV monitor that can handle
the 1080i video output format.
• 720p (Progressive Scanning)
Use this setting for an HDTV Ready 16 X 9
(WIDESCREEN) aspect ratio TV monitor that can handle
the 720p video output format.
• 480p (Progressive Scanning)
Use this setting for an Digital Ready 4 X 3 aspect ratio
TV monitor with Progressive Scan DTV ready compo-
nent video inputs that can handle the 480p video out-
put format.
The TV monitor may be labelled Enhanced Definition or
Progressive Scan, but not Wide Screen.
• 480i (Interlaced Scanning).
Use this setting for a conventional TV with regular
video, S-Video, or component video inputs.
NOTE
The use of 1080i on a 4 X 3 monitor or the use of 480p on a
16 X 9 monitor may cause Aspect Ratio picture distortion.
720p will only work on selected HDTV Ready TVs. Check the TV
monitor's owner's manual to verify this capability. 480i will
only work on conventional TV sets.