Sanitaire SC899 - Manual (Page 6)

Rating Plate
The model, type, and serial numbers are
indicated on the rating plate located on
the underneath side of the cleaner. For
prompt and complete service information,
always refer to these numbers when
inquiring about service.
Model & Type ____________________
Serial No. _______________________
HOW TO ASSEMBLE
Assembly Packet
The assembly packet is with the owner’s
guide. The packet contains two 2-part
bolts and two cord hooks. An extra drive
belt is also included with some models.
Step 1
Assemble the Handle
Slip the upper handle and the lower handle
together so the handle bolt holes align and
the slots in the handle are positioned as
shown in Detail A. Insert a 2-part bolt (A)
in the center of the handle and tighten.
Hold the assembled handle so it curves
away from the cleaner. Then push the
handle into the handle socket (D) at the
rear of the cleaner. Align the holes, insert
the other 2-part bolt (A), and tighten.
GENERAL INFORMATION
The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or
sharp objects with the cleaner to prevent bag tears, hose clogs, and fan blade breakage
with subsequent motor damage.
Service Information
The instructions in this booklet serve as a guide to routine maintenance. For additional
service information telephone our toll free number for the nearest Eureka/Sanitaire
Authorized Warranty Station. Refer to The Sanitaire Commercial Warranty for complete
service information. You should know the model, type and serial numbers when
you call:
USA: 1-800-282-2886
Mexico: 5670-6169
Canada: 1-800-282-2886
DO NOT OIL the motor or the brush roll at any time. The bearings are
permanently lubricated and sealed.
MODEL TYPE SERIAL NO.
VOLTS AMPS. HERTZ
SERVICE INFORMATION: 1-800-282-2886
D
A
C
A
B
Detail A
6