Scotts S2546 - Manual (Page 29)

Service Engine - Page 26
SERVICE ENGINE
7. Remove old filter (C) and wipe off filter tray with a clean
cloth.
8. Lightly oil filter gasket with fresh, clean oil.
9. Install replacement oil filter. Turn oil filter to the right
(clockwise) until rubber gasket contacts filter adapter.
Tighten filter an additional one-half turn.
10.Remove dipstick (B) and refill with new oil of
recommended grade. (See Engine Oil in this section.)
11.Check oil level. For correct procedure see Checking Oil
Level in this section.
12.Oil level must be between ADD and FULL marks. Do not
overfill.
13.Install and tighten dipstick. Lower hood.
14.Start engine and check for oil leaks. Correct any leaks
before operating.
15.Run engine at idle for 30 seconds. Stop engine. Wait 30
seconds and check oil level.
16.If necessary, add oil to bring level to FULL mark on
dipstick.
Checking and Cleaning Air Cleaner
Elements
1. Lift hood.
2. Clean any dirt and debris from the air cleaner before
removing cover.
3. Loosen knob (A) and remove cover (B).
C
MX1529
IMPORTANT: Avoid machine damage. To extend
engine life, when operating mower in extreme heat,
dust or other severe conditions, it may be necessary
to check/replace air cleaner more frequently.
B
A