SATO MB400 - Manual (Page 10)

MB400 Quick Guide Pg 7
Charging the Battery Pack
You can recharge the battery pack by inserting into the battery charger.
1. Plug one end of the AC adapter into the battery charger and the other end into the
wall outlet.
2. Insert the battery pack. Make sure the connector on the battery pack is facing down
and insert into the charger.
• The CHARGE indicator lights up in red when charging starts.
• The CHARGE indicator lights up in green when charging is completed.
(Fully charged)
3. When charging is completed, remove the battery pack from the charger.
MB400
Quick Guide Pg 12
[Dispense Mode]
First perform the previous Steps 1 to 6.
• Pick the Dispense/Continuous switch lever
from both sides and slide the Dispenser unit to
the direction of the arrow.
• Leave more than 30mm of the label out for the
Dispense mode.
• Slide the Dispenser unit until it is set in place.