SATO MB400 - Manual (Page 5)

MB400 Quick Guide Pg 17
Status
(LED) Mode Details Cause Solution
Green
(blinking) On-Line
(Printing
/Receiving
data) Buffer near full Approaching the
buffer quota Pause the data
transmission
and wait till the
buffer is empty
before trying
again.
Red
(blinking) All Modes Low Battery Batteries are not
recharged
properly. Recharge the
batteries.
The power will automatically be turned off 30 seconds after “Low Battery” is indicated. Make
sure the power is off before removing the battery pack and recharge the battery.
MB400 Quick Guide Pg 2
Installation
Remove the MB400 from its packing container. Check to make sure you have the following
items:
Other Accessories
• Cable Lock - Attached to the interface connector.
• Adjustment Screwdriver - Located inside the printer (under
the label feed area).
Quick Guide
Shoulder belt
Battery pack
Printer
* The shape of the protector
pads to hold the printer in place
may differ from the picture
shown.