Sony Ericsson Bluetooth Enabled Hands-Free Kit /Headset - Manual (Page 15)

14
5. Press Menu. Scroll to Bluetooth, SELECT and Search for audio accessories, SELECT. The
phone is now scanning for Bluetooth devices. SELECT the headset. The phone will initiate
connection with the headset.
QUICK ACCESS (for step 5):
Press Menu followed by the sequence of numbers below.
Bluetooth Search for audio accessories
8910 10 2
6. Enter “0000” as the passcode then press OK. The volume level will be displayed. The phone
is now connected with the headset.
7. Press Back then Exit to exit the Menu.
The headset is paired and ready to use. An icon will be displayed during the standby mode
indicating that the headset is linked with the phone.
Note: Once paired, the headset and the phone have simultaneous connection with each other
(keypad tones can be heard on the headset every time the keypad is pressed).
c. AUTO ACCEPT MODE
The auto accept mode allows the Bluetooth function to be turned on automatically whenever the
user starts sending information such as answering or making a call via the Bluetooth headset.
1. Press Menu. Scroll to Bluetooth, SELECT. Scroll to View paired devices, SELECT.
2. Select the headset and press OPTIONS. Scroll to Request conn. authorisation, SELECT. No,
SELECT.
3. Continue pressing Back button to exit the Menu.
QUICK ACCESS:
Press Menu followed by the sequence of numbers below.
Bluetooth View paired devices Select
8910 10 4 Options
d. ANSWERING/RECEIVING A CALL
When the phone is receiving a call, a ring tone will be heard on the headset as well as on the
phone.
1. Press the multi-function button down once to answer the call.
2. End the call by pressing the button again.
Note: Cell phone buttons can also be used to answer a call but audio is still transferred to the headset.
e. MAKING A CALL with the headset on
Normal dialing
1. Enter the contact number and send. As you dial, audio and the keypad tones can be
heard on the headset simultaneously but not on the phone.
2. Press the multi-function button to hang-up and terminate the call.
Note: If the call is terminated using the cellular phone, a tone will be heard on the headset
indicating that the call has been terminated.
Voice dialing
Refer to step g for the procedure when recording for voice dialing.
1. Press the multi-function button once to activate the voice dialing.
2. A beep will then be heard on the headset prompting the user to say the name of the
person to call.
3. Say the name. The name will be played back to you. The phone will then place the call
automatically. In case the cellular phone does not recognize the name spoken, the
steps above may be repeated.
4. Press the button again to terminate the call.
Redialing
Press quickly the multi-function button twice to redial the last number.
f. REJECTING A CALL
Press the multi-function button twice to reject the incoming call.
g. SETTING THE VOLUME
The headset has a digital volume control and is combined with the multi-function button. Setting the
volume can be done during calls or every time a key is pressed on your cell phone.
1. Press it clockwise to increase the volume.
2. Decrease the volume by pressing it counter-clockwise.