Sony Ericsson Bluetooth Enabled Hands-Free Kit /Headset - Manual (Page 9)

8
USING WITH SONY ERICSSON T39m
a. ACTIVATING THE BLUETOOTH
You must activate your Bluetooth to establish a Bluetooth connection between
your mobile phone and other Bluetooth devices.
1. Press the Menu Key. Scroll to Extras and press YES. Select Operation mode, YES. On,
YES.
2. Continue pressing NO, to exit.
QUICK ACCESS:
Press Menu followed by the sequence of numbers below.
Extras Bluetooth Operation mode
T39m 5 6 4
b. PAIRING TO THE CELLULAR PHONE
1. Bring the cellular phone at about 20 cm from the headset.
2. Detach the headset from the holster/base.
3. Turn off the headset.
4. From the OFF state, press the multi-function button for 10 seconds or until a distinctive three-
tone sound will be heard and at the same time the red and blue indicator will alternately blink.
Press the multi-function button once (headset mode). This indicates that the unit is now ready
for pairing.
5. Press the Menu Key. Scroll to Extras, YES. Select Bluetooth, YES. Select Paired devices,
YES. Add device, YES. Choose Phone initiates, YES. Choose Headset, YES. The phone will
then search the device to be added. After the device is found, press YES.
QUICK ACCESS (for steps 5 and 6):
Press Menu then follow the sequence of numbers below:
Extras Bluetooth
Paired
devices
Add
device
Phone
initiates
Headset
T39m 5 6 2 Yes 1 2
6. Enter “0000” as the passkey. If the pairing is successful, the alternating red/blue lights will
stop. Press YES to confirm the name of the device. If the pairing is unsuccessful, the steps
above may be repeated.
7. Continue pressing NO to exit the menu key.
The unit is now ready to link calls from the phone directly to the headset.
c. ANSWERING/RECEIVING A CALL
When the phone is receiving a call, a ring tone will be heard on the headset.
1. Just press the multi-function button down once to answer the call. Pressing the button again
will hang-up and terminate the call.
2. If you wish to answer a call on the cellular phone, just press YES and the call is automatically
transferred to the phone. Pressing the multi-function button transfers the call on the headset.
3. To terminate the call, press the multi-function button again.
d. MAKING A CALL with the headset on
Normal dialing
1. Enter the contact number and press YES. Audio can be heard on the headset at the
same time, a question will be displayed. Retrieve call in phone?, ignoring or pressing
No, transfers the call to the headset. Pressing Yes, transfers the call to the cell phone.
2. Press the multi-function button to hang-up and terminate the call.
Voice dialing
Refer to step f and g for the procedure when activating and recording for voice dialing.
1. Press the multi-function button once to activate the voice dialing.
2. A beep will then be heard on the headset prompting the user to say the name of the
person to call.
3. Say the name. The name will be played back to you. The phone will then place the call
automatically. In case the cell phone does not recognize the name spoken, the steps
above may be repeated.
4. Press the button again to terminate the call.
e. SETTING THE VOLUME
The headset has a digital volume control and is combined with the multi-function button. Setting
the volume can be done during calls only.
1. Press it clockwise to increase the volume.
2. Decreases the volume by pressing it counter-clockwise.