Sony SMP-N100 - Manual (Page 3)

3
Precautions
This equipment has been tested
and found to comply with the
limits set out in the EMC
Directive using a connection
cable shorter than 3 metres.
On placement
• Place the player in a location
with adequate ventilation to
prevent heat build-up in the
player.
• Do not place any objects on
the player, or do not place the
player on a soft surface, such
as a rug, as it may block the
ventilation holes.
• Do not install this player in a
confined space, such as a
bookshelf or similar unit.
• Do not place the player in a
location near heat sources, or
in a place subject to direct
sunlight, excessive dust, or
mechanical shock.
• Do not place the player
outdoors, in vehicles, on ships,
or on other vessels.
• Do not install the player in an
inclined position. It is
designed to be operated in a
horizontal position only.
• Do not place metal objects in
front of the front panel. It may
limit reception of radio waves.
• Do not place the player in a
place where medical
equipment is in use. It may
cause a malfunction of
medical instruments.
• If you use a pacemaker or
other medical device, consult
your physician or the
manufacturer of your medical
device before using the
wireless LAN function.
• This player should be installed
and operated with a minimum
distance of at least 20 cm or
more between the player and a
person’s body (excluding
extremities: hands, wrists, feet
and ankles).
• Do not place heavy or unstable
objects on the player.
• Disconnect the AC power cord
(mains lead) and all other
cables from the player when
you move the player.
On power sources
• The player is not disconnected
from the AC power source
(mains) as long as it is
connected to the wall outlet,
even if the player itself has
been turned off.
• Disconnect the player from the
wall outlet if you are not going
to use the player for a long
time. To disconnect the AC
power cord (mains lead), grasp
the plug itself; never pull the
cord.
• Observe following points to
prevent the AC power cord
(mains lead) being damaged.
Do not use the AC power cord
(mains lead) if it is damaged,
as doing so may result in an
electric shock or fire.
– Do not pinch the AC power
cord (mains lead) between
the player and wall, shelf,
etc.
– Do not put anything heavy
on the AC power cord
(mains lead) or pull on the
AC power cord (mains lead)
itself.
On AC adapter
• Use the supplied AC adapter
(AC-NX1W) for this player, as
other adapters may cause a
malfunction.
• Do not disassemble or reverse-
engineer.
• Do not confine the AC adapter
in a closed place such as a
bookshelf or an AV cabinet.
• Do not connect the AC adapter
to a traveler’s electric
transformer, which may
generate heat and cause a
malfunction.
• Do not drop or apply shock.
On adjusting volume
Do not turn up the volume while
listening to a section with very
low level inputs or no audio
signals. If you do, your ears and
the speakers may be damaged
when a peak level section is
played.
On cleaning
Clean the cabinet, panel, and
controls with a soft cloth. Do not
use any type of abrasive pad,
scouring powder or solvent such
as alcohol or benzine.
On replacement of parts
In the events that this player is
repaired, repaired parts may be
collected for reuse or recycling
purposes.
On connecting to the HDMI
OUT jack
Observe the following as
improper handling may damage
the HDMI OUT jack and the
connector.
• Carefully align the HDMI
OUT jack on the rear of the
player and the HDMI
connector by checking their
shapes. Make sure the
connector is not upside down
or tilted.
• Be sure to disconnect the
HDMI cable when moving the
player.
• Hold the HDMI connector
straight when connecting or
disconnecting the HDMI
cable. Do not twist or force the
HDMI connector into the
HDMI OUT jack.
,continued