Stewart Filmscreen Corp 4-Way ScreenWall ElectriMask - Manual (Page 14)

12 Stewart Filmscreen Corporation
Installing the low-voltage 3-button switch option
The optional Stewart Filmscreen low-voltage control allows the use of low-
voltage wire to connect to the supplied 3-position momentary wall switch.
Preparing the connection
Before making the electrical connections, you need:
‹ An available AC constant power source
‹ A 4-conductor switch hook-up cable (4-conductor bell wire or
category 5 cable is typically used for long runs)
‹ A 4-conductor high-voltage hook-up cable, if the control is to be
mounted at a location away from the frame
‹ Cat 5, multi-conductor unshielded, or similar type electronic cable
can be used to connect the 3-button switch to the LVC. The
recommended wire gauge is 20 to 24 AWG. Use plenum-rated
cable when required.
Making the connection
Figure 10 illustrates the connections.
1. Mount the low-voltage control box near the mask.
2. Connect the low-voltage control box to the mask by connecting
the mask motor power leads to the power strip terminal block
located on the circuit board of the control box.
3. Connect the low voltage control box to the AC power source by
connecting the AC line voltage to the power strip terminal block
located on the circuit board of the control box.
4. Connect the switch to the low-voltage control box.
5. A parallel connection to an outboard audio-visual switching
network can be made at this time. (optional) Use only momentary
switches for this option.
Figure 10: Low voltage 3-button switch wiring
3-button
Momentary Switch
AC Power
Line
R/F Input
InfraRed Input
Low Voltage
Switching
Neutral
COMMON-White
UP-Red
DOWN-Black
GROUND-Green
STOP-Yellow
COMMON-White
UP-Red
DOWN-Black
4 Conductor Hook-up Cable
20-24ga Recommended
Category 5 Typically Used
(NOT Supplied)
Low Voltage Control Box