Stewart Filmscreen Corp 4-Way ScreenWall ElectriMask - Manual (Page 6)

Preparation
Specifications regarding the individual screen dimensions, weight, mounting
type, and controls are provided by the factory when the unit is ordered.
Before beginning the installation:
‹ Check the specifications for the type of mounting and switch
control to be used.
‹ Prepare the wall for electrical access to the motor(s) (audience
left).
‹ Make sure there is a clean surface on which to unroll the screen.
‹ Check the size and weight of the screen to be installed so that
you can plan for the number of people required for the mounting
procedure. You need at least two people to mount the smaller
screens; more are needed for larger, heavier screens.
You will need:
‹ Enough ladders for the personnel supporting the screen during
the mounting process
‹ A level
‹ Fasteners appropriate for the surface on which the screen is
being mounted (See instructions for the type of mount for
recommendations.)
‹ Phillips screwdriver
‹ 5/8” (1.6 cm) hex head screwdriver or Allen wrench
Unpacking
Remove the outer plastic covering and white wrapping paper surrounding
the frame unit, if any. Do not remove the screen from the cardboard
shipping tube until instructed to do so.
4 Stewart Filmscreen Corporation
P
REPARING THE
I
NSTALLATION
‹ Before proceeding with the installation of this screen,
take time to thoroughly read and understand these
installation and operation instructions.
‹ All electrical wiring installations must conform to local
and national codes and should be performed by
qualified service personnel.
‹ There are no user-serviceable parts contained within
the unit.
Caution
During installation, do not place the unit on an unstable
cart, stand, table, or ladder. The unit may fall, causing injury
to a child or adult and damage to the unit.