Sony Ericsson LMD-2030W - Manual (Page 10)

10 Location and Function of Parts and Controls
Rear Panel
a
HDMI IN connector
HDMI (High-Definition Multimedia Interface) is an interface that
supports both video and audio on a single digital connection,
allowing you to enjoy high quality digital picture and sound. The
HDMI specification supports HDCP (High-bandwidth Digital
Content Protection), a copy protection technology that
incorporates coding technology for digital video signals.
Note
Use HDMI compliant cable (optional) with HDMI logo.
b OPTION IN connector (D-sub 9-pin, female)
Inputs SDI signals when optional Sony input adaptor BKM-320D
is connected.
Press the SDI button to select the signal.
Note
Do not connect the equipment other than BKM-320D. It causes
damage to the unit or the equipment.
c
OPTION AUDIO IN connector (phono jack)
Inputs an audio signal if the BKM-320D is connected to the
OPTION IN connector.
Press the SDI button to monitor the audio signal.
d
EXT SYNC IN/OUT (external sync) connectors
(BNC)
Press the EXT SYNC button to use the sync signal through this
connector.
IN connector
When this unit operates on an external sync signal, connect the
reference signal from a sync generator to this connector.
Note
When inputting a video signal with the jitters, etc. the picture
may be disturbed. We recommend using the TBC (time base
corrector).
OUT connector
Loop-through output of the IN connector. Connect to the
external sync input of video equipment to be synchronized with
this unit.
When the cable is connected to this connector, the 75-ohms
termination of the input is automatically released, and the
signal input to the IN connector is output from this connector.
e
RGB/COMPONENT connectors
Analog RGB signal or component (Y/P B /P R ) signal input
connectors and their loop-through output connectors.
Press the RGB/COMPONENT button to monitor the signal input
through these connectors.
G/Y, B/P B , R/P R IN/OUT (BNC)
These are the input/output connectors for an analog RGB and a
component (Y/P
B /P R ) signal. Unless an external sync signal is
input, the monitor is synchronized with the sync signal
contained in the G/Y signal.
AUDIO IN/OUT (phono jack)
When using an analog RGB or a component signal as a video
signal, use these jacks for the input/output of an audio signal.
Connect them to the audio input/output jacks on equipment
such as a VCR.
f
PARALLEL REMOTE connector (modular
connector, 8-pin)
Forms a parallel switch and controls the monitor externally.
For details on the pin assignment and factory setting function assigned to
each pin, see page 21.
CAUTON
For safety, do not connect the connector for peripheral device
wiring that might have excessive voltage to this port. Follow the
instructions for this port.
LINE A PARALLEL REMOTE RGB/COMPONENT
VIDEO IN OUT
IN OUT
IN OUT G/Y IN OUT
B/P B
IN OUT EXT
SYNC
IN OUT
R/P R IN OUT AUDIO AUDIO IN
IN
OUT
AC IN
OPTION
AUDIO IN
OPTION IN
3 2 1 4 5 6 7 8